Technical Information

New 2-Channel Remote Programming (July 2017)

MOTORS WITH RED LEARNING BUTTON — Motor Jogs

Press and hold the learning button for the desired number of jogs then release.

  1. One Jog = Pairing mode — press and hold for one jog then release.
  2. Two Jogs = Disable shade — press and hold for two jogs then release — (Recover shade/motor by pressing learning button for one second then release).
  3. Three Jogs = Reverse the motor direction of travel — press and hold for three jogs then release.
  4. Four Jogs = Factory reset — press and hold for four jogs then release.

SECTION 1 — To Sync a Remote to a Shade

  1. Decide which channel on the remote.
  2. Press and hold learning button until shade jogs and beeps one time.
  3. Press and release P2 on the remote (shade will jog).
  4. Press and release P2 on the remote (shade will beep).
  5. Press and release the up or down button (shade will jog and beep 6x).

SECTION 2 — Limit Setting Mode

  1. Press and release P2 on the remote (shade will jog and beep one time).
  2. Press the up button on the remote (shade will jog and beep one time).
  3. Press and release P2 on the remote (shade will jog and beep four times) to confirm you are in limit setting mode.
  4. Use the up or down button to move shade to desired upper or lower stop point (for fine tune adjustment press and release P2 while the shade is moving) and press stop. Once you have shade at desired location press and hold the stop button until it beeps four times and jogs once. Shade will jog and beep one time to confirm limit is set.
  5. If limits need to be adjusted after they have been set, please delete limits first (see next section), then start over at section 2.

SECTION 3 — Deleting Limits

  1. Press and release P2 on the remote (shade will jog and beep).
  2. Press the down arrow on the remote (shade will jog and beep).
  3. Press and release P2 on the remote (shade will jog and beep 4 times to confirm all limits are deleted).

SECTION 4 — Controlling Multiple Motors / Shades With a Single Channel

  1. Start by pairing and setting limits on the first shade/motor (see section 1 and 2).
  2. Press and hold learning button on the first shade for two jogs and release. The motor will beep confirming that it has been disabled.
  3. Move on to the next shade and repeat the above steps (using the same channel).
  4. Once you have all shades/motors programmed, you will recover the disabled shades by pressing and releasing the learning button for about one second.
  5. All shades should now work together.

*CLEAR LEARNING BUTTON MOTORS — Motor Jogs

Press and hold learning button for the desired number of jogs then release.

  1. One Jog = Pairing mode — press and hold for one jog then release.
  2. Two Jogs = Reverse the motor direction of travel — press and hold for two jogs then release.
  3. Three Jogs = Factory reset — press and hold for three jogs then release.

AIRXCEL, INC. — MCD Innovations
3303 North McDonald St.
McKinney, TX 75071
[email protected]

P: 800.804.1757
F: 972.542.4881

MCD a division of Airxcel

Copyright © 2018 MCD Innovations